The easiest way is to configure the phone's switchport in vlan-voice mode only: the phone will be directly connected in the voice vlan and won't require additional configuration. When you use Vlans, there are multiple options to set this information on the phone. The following option 160 are then to be used:įor the other parameters to set to use HTTPS provisioning, see this document. The Polycom Phone Support module v.4.5.0+ supports HTTPS provisioning. Value: ", where "SOP_IP" is the IP address of the SOP.The following option 160 are then to be used: The Polycom Phone Support module v.3.1+ supports HTTP provisioning. Value: "tftp://SOP_IP", where "SOP_IP" is the IP address of the SOP.Without this DHCP option, you will have to change the setting manually on each phone the first time it boots. Escaux provisions phones by using the TFTP protocol. These options are not mandatory when not using Polycom phones, but we advise to set them anyway.īy default, a Polycom phone uses the FTP protocol to download its configuration file. Polycom phones use more configuration DHCP options. This value is mandatory for all deployments. This page is used to give you an overview of the most used DHCP options.ĭHCP option 66 (tftp-server-name) is used to tell the phone (also ATA box) which server he has to contact to download his configuration file. Via non-standard DHCP options, the device receives additional configuration options. When a device such as a phone is connected to the network, it will get an IP address from the DHCP server. Configuration for Microsoft Windows DHCP servers.Configuration for a ISC DHCP server 3.x.x.Cisco specific DHCP options (not needed for ATA).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |